Excalibur AL-1650-EDPB Installationsanleitung PDF herunterladen (Seite 4)

18 Pin Secondary W

ire Harness (cont’d)

CONNECTION (Manual Transmission):

Connect this to the brake switch wire that shows (-)

ground when the parking brake is engaged

�

VIOLET/WHITE WIRE - TACH SIGNAL INPUT

This input provides the engine’s RPM signal to the remote start� This is typically the most reli-

able form of engine detection

� T

o use the tach wire, you must change installer feature #6 to the

tach wire setting

�

CONNECTION: This can be connected to any trigger wire for an ignition coil, fuel injector

, or the

signal to the tachometer in the dash

� Use a digital multimeter set for AC volts to test� The appropri

ate wire will read between 1-6 volts AC and will increase as the engine RPM increases

�

BROWN WIRE - SIREN (+) OUTPUT

This output provides a 1 amp positive output to operate the included siren�

CONNECTION: Safely route this wire to the chosen mounting location of the siren and connect it

to the siren’s red wire� Connect the siren’s black wire to chassis ground�

WHITE WIRE - FLASHING LIGHT (+) OUTPUT

Thisoutputprovidesa10amppositiveoutputtoashthevehicle’sparkinglights(typically).If

the vehicle has a low current negative parking light circuit, use the WHITE/BLACK wire instead�

CONNECTION: Connect this wire to the vehicle’s positive parking light circuit� It will show +12

volts when the parking lights are on� BE SURE NOT TO CONNECT TO THE DIMMER CIRCUIT

WHICH WILL CHANGE VOLTAGE AS YOU TURN THE DIMMER KNOB�

WHITE/BLACK WIRE - FLASHING LIGHT (-) OUTPUT

Thisoutputprovidesa250mAnegativeoutputtoashthevehicle’sparkinglights(typically).If

the vehicle has a positive parking light circuit, use the WHITE wire instead�

CONNECTION: Connect this wire to the vehicle’s negative parking light circuit� It will show ground

when the parking lights are on� BE SURE NOT TO CONNECT T

O THE DIMMER CIRCUIT-

WHICH WILL CHANGE RESISTANCE TO GROUND AS YOU TURN THE DIMMER KNOB

�

GRAY WIRE - HOOD TRIGGER (-) INPUT

REQUIRED� This input is used to detect entry into the hood area of the vehicle� It is also a criti-

cal safety circuit that prevents remote start functions while the hood is opened�

CONNECTION: Connect this wire to the vehicle’s existing hood switch or light� It will show ground

when the hood is opened� Y

ou can also use the included pin switch and mount it to the radiator

core support

�

GREEN WIRE - DOOR TRIGGER (-) INPUT

This input is used to detect entry into the vehicle via any door opening�

CONNECTION: Connect this wire to the vehicle’s existing domelight circuit or door pin circuit� The

circuit will show ground when any door is opened� If you are required to connect to each individual

door pin, diode isolation is required� Use one 1-2 amp diode for each door, facing the diode’

cathode (stripe) towards the vehicle wiring

�

VIOLET WIRE - DOOR TRIGGER (+) INPUT

This input is used to detect entry into the vehicle via any door opening�

CONNECTION: Connect this wire to the vehicle’s existing domelight circuit or door pin circuit�

The circuit will show +12 volts when any door is opened� If you are required to connect to each

individual door pin, diode isolation is required� Use one 1-2 amp diode for each door, facing the

diode’

s cathode (stripe) towards the alarm module

�

1 2 3 4 5 6 7 8 9 ... 13 14

Kommentare zu diesen Handbüchern

Keine Kommentare

Excalibur AL-1650-EDPB Installationsanleitung Seite 4

Kommentare zu diesen Handbüchern